Offset Value turns junk value

[Mallikarjuna]

Hello Greg,

Sometimes, I have observed that when we change adjusted cycled length, and change offset and edit timing window, the offset value automatically turns to a junk (random number) value. I don't know why does that happen. I have been adding a new timing plan and doing some modification to Adj. cycle length and offset, and timing window. But I see that offset value changes to some other value after I clicked NEXT or say OK. Once again, if change that number and save the document, it remains constant. I don't know it is bug and something, I just wanted to let know about the problem.

Thank you
-Arjun

[bullock]

Thank you for reporting that, Arjun.

Can you reproduce the problem at will? Does it seem to occur only at certain intersections, or can it occur anywhere? If there's a particular case that demonstrates the problem, perhaps you would send the file to me and help me reproduce it.

Any further help you can provide in isolating the pattern would be most appreciated.

Regards.
Greg